IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 17 page image

IDS816 User Manual 700-283-01H Issued January 2009175. Enter the [NEW CODE] followed by the [*] key.6. The READY and ARMED indicators will flash simultaneously.7. To edit other codes repeat steps 3 to 5.8. Press the [#] key to exit the User Program Mode.13.413.413.413.4 View aView aView aView a UserUserUserUser CCCCodeodeodeode Slot NumberSlot NumberSlot NumberSlot Number –––– Option 3Option 3Option 3Option 3Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [3] [*] [USER CODE] [*]1. Enter the User Program Mode as per steps 1 to 4 on page 14.2. Press the [3] key followed by the [*] key to select programmable option 3. The READY andARMED indicators will flash simultaneously.3. Enter the [USER CODE] followed by the [*] key.4. The READY indicator will flash and the AWAY indicator will be on.5. The [USER CODE] slot number will be displayed by the Zone indicators. (See table 2)6. Press the [#] key to exit the User Program Mode.13.513.513.513.5 UserUserUserUser CCCCodeodeodeode PropertiesPropertiesPropertiesProperties –––– Option 4Option 4Option 4Option 4Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [4] [*] [USER CODE] [*] [PROPERTY No.] [*]1. Enter the User Program Mode as per steps 1 to 4 on page 14.2. Press the [4] key followed by the [*] key to select programmable option 4. The READY andARMED indicators will flash simultaneously.3. Enter the [USER CODE] followed by the [*] key.4. The READY indicator will flash and the AWAY indicator will be on.5. The properties assigned to the user code are displayed by the Zone indicators. LED(s) that are onindicate that certain properties have been assigned to the user code. Refer to Table 2 for a list ofuser code properties.6. To select a user code property, press the key which corresponds to that property followed by the[*] key. The appropriate zone LED will come on. To deselect a property, press the correspondingkey followed by the [*] key and the LED will be turned off.Example:To enable a user code to function as a duress code press the [2] key followed by the [*] key. Thezone 2 LED will come on to confirm the selection.7. Repeat step 6 until the desired properties have been programmed.8. Press the [#][#][#][#] key to exit the User Program Mode.