IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 20 page image

IDS816 User Manual 700-283-01H Issued January 20092013.1013.1013.1013.10 Viewing a User NameViewing a User NameViewing a User NameViewing a User Name –––– Option 11Option 11Option 11Option 11(Slot Known(Slot Known(Slot Known(Slot Known))))(LCD Keypad only)Hold down the [*] key until the beep,then enter [MASTER CODE] [*] [1] [1] [*] [SLOT NUMBER] [*] [#]1. Enter the User Program Mode as per steps 1 to 4 on page 14.2. Press the [1] key then the [1] key again followed by the [*] key to select menu option 11. TheARMED and READY indicators will flash simultaneously.3. Enter the [SLOT NUMBER] followed by the [*] key.4. The user name will be displayed. Default names are displayed as the SLOT NUMBER (i.e. If theSLOT NUMBER has not been edited as per Option 1)5. Press [#] to exit User Program Mode.14.14.14.14. Stay ZonesStay ZonesStay ZonesStay ZonesStay zones are those zones that are bypassed automatically when the system is “STAY ARMED”. Toavoid triggering the alarm, zones such as bedrooms that are protected by Passive Infra-Red (PIR)detectors or windows that may be opened, must be bypassed when “staying at home”.Stay zones need only be programmed once. Each time the system is armed in the Stay Modethe pre-selected stay zones will be bypassed automatically. The panel allows for two unique STAYPROFILES to be stored. A STAY PROFILE stores a pre-selected combination of STAY and BUZZ zones tosuit a specific STAY ARM requirement.If a partition is stay armed using Profile one, it is possible to toggle the panel arm statusdirectly to Stay Arm Profile two by holding the [5] key for two seconds. STAY and BUZZ zones can beprogrammed for each profile once the profile has been selected (below).14.114.114.114.1 How to Select a Stay ProfileHow to Select a Stay ProfileHow to Select a Stay ProfileHow to Select a Stay ProfileHold down the [MODE] key until the beep,then enter [2] [*] [PROFILE NUMBER] [*]1. Ensure that the Panel is disarmed.2. Press the [#] key to clear any previous entries.3. Hold [MODE] down for one second until the keypad beeps.4. Press the [2] key followed by the [*] key.5. Press [1] or [2] for the required profile.6. Press [*] to enter. The buzzer will give a long beep.7. Program STAY and BUZZ zones for the profile (See pages 19 and 20) or ARM the profile14.214.214.214.2 How to Program Stay ZonesHow to Program Stay ZonesHow to Program Stay ZonesHow to Program Stay ZonesAfter selecting the required stay profile (Page 19),Hold down the [3] key until the beep,then enter [ZONE NUMBER] [*] [#]1. Select the required stay profile (See Page 19)2. Hold down the [3] key until the keypad buzzer sounds. The AWAY indicator will flash indicatingthat the panel is in the Stay zone programming mode.