IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 22 page image

IDS816 User Manual 700-283-01H Issued January 20092216.16.16.16. Chime ZonesChime ZonesChime ZonesChime ZonesThe chime mode allows the user to monitor nominated zones while the system is disarmed. The keypadbuzzer will sound five times when the nominated zone is violated - the siren will NOT sound and no alarmcondition will be reported.EXAMPLE:EXAMPLE:EXAMPLE:EXAMPLE:If you wish to know each time someone enters or exits the front door of your office, program this zone asa chime zone. The keypad will beep each time someone opens the front door.16.116.116.116.1 How to Program Chime ZonesHow to Program Chime ZonesHow to Program Chime ZonesHow to Program Chime ZonesHold down the [2] key until the beep,then enter [ZONE NUMBER] [*] [#]1. Select the required stay profile (See Page 19)2. Hold down the [2] key until the keypad buzzer sounds. The AWAY indicator will flash indicatingthat the panel is in the Chime zone programming mode.3. Entering a zone number will toggle the corresponding LED. For example, [2] [*] will turn LED 2 on(if it was off) and off (if it was on).4. Turn on the LED’s corresponding to the zones you need to be CHIME zones. The LED zoneindicators should now indicate only the zones that you require to be CHIME zones.5. Once satisfied with your selection, press the [#] key to exit the CHIME zone mode.17.17.17.17. Viewing Trouble ConditionsViewing Trouble ConditionsViewing Trouble ConditionsViewing Trouble ConditionsHold down the [7] key until the beepThe user is alerted to a trouble condition via a flashing power LED. It is also possible to enable a troublebeep. (Ask your Alarm Panel Installer)If the trouble beep has been enabled, the keypad buzzer will sound to alert the user that atrouble condition has occurred. Press the [#] key to silence the buzzer.Hold down the [7] key for two seconds. The ARMED, AWAY and READY indicators will beflashing simultaneously showing that the keypad is in the TROUBLE VIEW MODE. Refer to Table 3 to findthe significance of each on zone LED. The system will automatically exit the TROUBLE VIEWING MODEafter one minute. (Alternately to exit this mode press [#].)NOTE:Certain trouble conditions will only clear once the trouble condition has restored. To cancel the beepingwithout viewing the trouble conditions, press [#] key.