IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 12 page image

IDS816 User Manual 700-283-01H Issued January 2009126.56.56.56.5 KeyKeyKeyKey----sssswitch or Remote Arming (If Fwitch or Remote Arming (If Fwitch or Remote Arming (If Fwitch or Remote Arming (If Fitted)itted)itted)itted)1. Ensure that the READY indicator is on before leaving.2. Leave and close the door (remembering to lock!)3. Activate the remote or the key-switch. (A remote can be used to Stay Arm or Away Arm.) The panelwill arm in the away mode.NOTE:If a remote control is used it is advisable to have the siren toot on arm function enabled. This providesverification that the system has armed. (Speak to your installer about this feature)6.66.66.66.6 Auto ArmAuto ArmAuto ArmAuto ArmThe panel may be programmed to arm automatically at a pre-programmed time. Should the premises beoccupied at the time of auto-arming, a valid user code entered during the pre-arm delay will terminate thearming sequence. The pre-arm delay is signalled by an exit beep.7.7.7.7. Disarming the Control PanelDisarming the Control PanelDisarming the Control PanelDisarming the Control Panel7.17.17.17.1 How to DisarmHow to DisarmHow to DisarmHow to Disarm with awith awith awith a UUUUserserserser CCCCodeodeodeode[#] [USER CODE]1. Enter the premises through a designated entry route. Entering via any other route will cause analarm.2. As soon as the Entry/Exit zone is violated, the entry delay will begin. The keypad buzzer will soundfor the duration of the entry period.3. Press the [#] key and enter a valid [USER CODE].4. Once the system disarms, the ARMED indicator will turn off and the keypad buzzer will stopsounding.5. If no valid user code has been entered prior to the expiry of the entry delay period an alarmcondition will be registered.6. If the entry period is too short, have your installer change the entry delay period.NOTNOTNOTNOTEEEE::::If a strobe (or flashing light) has been installed and an alarm condition is registered, the strobe willcontinue flashing after the siren has stopped sounding. Entering a valid user code will cancel the strobe.7.27.27.27.2 How toHow toHow toHow to DDDDiiiisarmsarmsarmsarm UUUUsing a Keysing a Keysing a Keysing a Key----sssswitch or Remotewitch or Remotewitch or Remotewitch or Remote1. Activate the remote or key-switch.2. The system will disarm and the remote indicator (if installed) will turn off. If the siren toot on disarmoption is enabled, the siren will provide a double toot when the panel is disarmedNOTE:Speak to your installer about activating this feature.