IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 14 page image

IDS816 User Manual 700-283-01H Issued January 200914 A PANIC ALARM may also be activated using any FIXED PANIC button or a REMOTE PANICbutton (if installed). If the audible panic option has been selected, the siren will sound. A PANIC ALARM will betransmitted to the monitoring company. To silence the siren, enter a valid [USER CODE]. Press the [P] key only in an emergency situation that requires response by emergency personnel.9.39.39.39.3 Medical AlarmsMedical AlarmsMedical AlarmsMedical AlarmsHold down the [M] key until the beep If the [M] key is pressed until the keypad beeps (approximately 1 second) a MEDICAL ALARMcondition will be activated. The keypad buzzer will beep 5 times. A medical reporting code will be reported to the monitoring company.9.49.49.49.4 DuressDuressDuressDuress AlarmsAlarmsAlarmsAlarms[#] [DURESS CODE] This is a special user code that should only be used in the unique situation where an intruderforces one to disarm the system “under duress”. When a [DURESS CODE] is entered, the control panel disarms. A Duress Alarm Code (if programmed) will be reported to the monitoring company, but the sirenwill not sound.. It is advisable to choose a Duress code that can be easily remembered by all family (or staff)members.10.10.10.10. Alarm MemoryAlarm MemoryAlarm MemoryAlarm MemoryHold down the [0] key until the beepThe Alarm Memory displays any zones that were violated, tampered with, or bypassed during the lastarm cycle. A flashing ARMED indicator notifies the user of an alarm memory condition. To view the alarmmemory, disarm the panel and continue as follows:1. Hold down [0] until the keypad buzzer sounds.2. The READY and POWER indicators will turn off and the keypad buzzer will sound briefly.3. Zone indicators that are on, show which zones were violated during the last armed period.4. Press 2 to display zones that were bypassed.5. Press 3 to display which zones were tampered with.6. Press 1 to return to violated zones.7. Note that the alarm memory is erased at the beginning of each arm cycle – so it should always bechecked BEFORE re-arming, if necessary.