IDS 816 User Manual

Also see for 816: Installer manual User manual

IDS 816 User Manual Manual pdf 15 page image

IDS816 User Manual 700-283-01H Issued January 20091511.11.11.11. UUUUser Codesser Codesser Codesser CodesThe IDS 816 Alarm Panel has 32 programmable user codes. By default, user code 1 is the Master UserCode that contains a pre-programmed 4-digit code of 1234.NOTENOTENOTENOTE::::User codes may be 4 (default) or 6 digits long (with default code of 123456). This is a programmablefeature. Check with your installer to verify which option has been programmed.11.111.111.111.1 Adding, Deleting and Editing UserAdding, Deleting and Editing UserAdding, Deleting and Editing UserAdding, Deleting and Editing User CCCCodesodesodesodesHold down the [*] key until the beep,then enter [MASTER USER CODE] [*] [PROGRAMMABLE OPTION] [*]The IDS 816 Panel has a friendly programmable interface that allows you to add, modify or delete usercodes. See Table 1 for a summary of programmable options. The programmable interface is accessedby entering the USER PROGRAMMING MODE.Table 1 User Programming OptionsOptionsOptionsOptionsOptions Summary of Programmable OptionsSummary of Programmable OptionsSummary of Programmable OptionsSummary of Programmable OptionsOption 0 Allows for the addition of new user codes.Option 1 Allows editing of the user name displayed by LCD keypads.This option is only applicable if LCD keypads are installed.Option 2 Allows editing of a selected user code.Note that the user code properties are not edited, only the user code itself.Option 3 Allows viewing of the user code slot number for a selected code.There are 32 available user code slots.Option 4 Allows editing of the user code properties for a selected user code.This is a bit mapped menu.Option 5 Allows the allocation of a selected user code to a designated partition(s).This is a bitmapped menu.Option 8 Adding User Remotes.Option 9 Deleting a User Code.Option 10 Allows the deletion of a user code using the user code slot number.Option 11 Allows viewing of a user name if the slot number is known.12.12.12.12. User Program ModeUser Program ModeUser Program ModeUser Program Mode1. Ensure that the panel is not armed.2. Hold down the [*] key until the keypad buzzer sounds.3. The ARMED and READY indicators will flash alternately.4. Enter a [MASTER USER CODE]. The factory default is 1234. Should the [MASTER USERCODE] be defaulted to six digits, it will be 123456. Press the [*] key. A valid entry will beconfirmed by a long beep.5. If steps 1 to 4 are performed correctly, the READY indicator will flash. If an invalid code wasentered, the keypad buzzer will give an error beep. (3 short beeps). If the error beep occurs, pressthe [#] key (this clears all previous entries) and repeat steps 2 to 5.6. Select a programmable option from Table 1.