Icom IC-M502 Instruction Manual

Also see for IC-M502: Operational manual Service manual Instruction manual Service manual Instruction manual

Icom IC-M502 Instruction Manual Manual pdf 13 page image

3BASIC OPERATION9n Call channel programmingThe call channel is used to select channel 9, however, youcan program your most often-used channels in each channelgroup for quick recall.q While pushing [HI/LO], push [CH/WX•DW•U/I/C] one ormore times to select the desired channel group (U.S.A., In-ternational, Canada) to be programmed.w Push [16•9] for 1 sec. to select the call channel of the se-lected channel group.• “CALL” and call channel number appear.• The order of indication precedence is “LOCAL,” “SP OFF” and“CALL.”e Push [16•9] again for 3 sec.(until long beep changes to2 short beeps) to enter callchannel programming con-dition.• Channel number starts flash-ing.r Rotate the channel selectorto select the desired chan-nel.t Push [16•9] to program the displayed channel as the callchannel.• Push [CH/WX] to cancel.• The channel number stops flashing.n Channel namesMemory channels can be tagged with alphanumeric namesof up to 10 characters each.Capital letters, small letters, numerals, some symbols (! " # $% & ' ( ) Q + , – . ⁄ ) and spaces can be used.q Select the desired memory channel.• Cancel dual watch, tri-watch or scan in advance.w While pushing [HI/LO], push [16•9] to edit memory chan-nel name.• A cursor appears and blinks.e Select the desired character by rotating the channel selec-tor or by pushing [Y]/[Z] on the microphone.• Push [SCAN] or [CH/WX] for cursor movement.r Push [16•9] to input and set the name.• Push [HI/LO] to cancel.• The cursor disappears.t Repeat steps q to r to program other memory channelnames, if desired.INT25WTAGäLEASUREINT25W CALLTAGCALLINGINT25W CALLDUPTAGINTL