10310BAND SCOPE (Multi-function receiver/Component screens only)10■ Wide band scope functionThe wide band scope function is available to sweep a wideband scope (±1, 2 or 5 MHz.)While sweeping the band scope, AF monitor function is alsoavailable.qRight-click the zFREQx button to call up the [Scope(FREQ)] setting screen if it is not displayed.wCheck the [Enable] check box in [Wide Band Scope] to en-able the wide band scope function.• Check the [AF Monitor] check box to monitor the receiving fre-quency.eClick the close ([X]) button to close the setting screen.■ Band scope optionsThe following optional functions are available for the bandscope function. These settings can be defined using the[Scope (FREQ)] screen.● WFM Monitor functionThe band scope function is normally used in AM and FMmodes only. This function allows it to be used as waveformmonitor in WFM mode.● 1/2 sweep step functionThis function sets the sweep step in half of the tuning step,doubling the sweep resolution.qRight-click the zFREQx button to call up the [Scope(FREQ)] setting screen if it is not displayed.wCheck the desired check boxes in [Option], then click theclose ([X]) button to close the setting screen.• [Scope (FREQ)] screenw Clickq Check the check boxes.• [Scope (FREQ)] screene Clickq Check the check box to turn[Wide Band Scope] ON.w Check the check box toturn [AF Monitor] ON.
