Icom IC-R2500 Instruction Manual

Also see for IC-R2500: Price list Service manual Instruction manual

Icom IC-R2500 Instruction Manual Manual pdf 30 page image

23MEMORY OPERATION5■ General descriptionThe receiver has 1100 memory channels including 100 scanedge memory channels (50 pairs) for storage of often-usedfrequencies. And a total of 21 memory banks, A to H, J to R,T, U, W and Y are available for storing groups of frequencies,etc. Up to 100 channels can be assigned to a bank.DD Memory channel contentsThe following information can be programmed into memorychannels:• Operating frequency (p. 13)• Receive mode (p. 13)• Tuning step (p. 12)• Attenuator ON/OFF (p. 15)• IF filter selection (p. 18)• Duplex direction (DUP+ or DUP–) with an offset fre-quency (p. 19)• Squelch control system ON/OFF and its frequency orcode (pgs. 39, 41, 43, 45)• Scan skip information (p. 36), etc.■ Memory channel selectionq Push the desired band’s [VFO/MR•S.MW] once or twiceto select memory mode.• “M” indicator appears.w Rotate the same band’s [DIAL] to select the desired mem-ory channel.• Programmed memory channels only can be selected.“!” indicator appears whenmemory mode is selected[VFO/MR•S.MW]If memory banks or weather channels* mode appears atstep q, push [MHz•TS] and rotate [DIAL] to select“bAnk --,” then push any keys for the main band or any ofthe shared keys below the display to return to channel se-lection.*Available for USA/CANADA versions only.