Icom IC-T22A Instruction Manual

Also see for IC-T22A: Instruction manual Instruction manual Service manual Instruction manual Instruction manual

© Programming after selection® Select the memory channel to be programmed:‘» Push [MR] to select memory mode.‘» Rotate [DIAL] (or use the keypad) to select the memorychannel.® Set the desired frequency in VFO mode:‘» Push [VFO] to select VFO mode.‘» Set the desired frequency using the keypad or [DIAL].‘> Set other data, if desired.® Push [FUNC] + [(ma)MW] for 0.5 sec. to program.© Memory/call = VFO@ Select the memory/call = pechannel to be transferred: Wy GA HitAnPush [MR] (or [CALL])to select memory (call)mode. Rengpnene» Rotate [DIAL](oruse+=thekeypad)to select the(<>)GRA-'“VF”appearsbrieflymemory channel.@ Push [FUNC] + [(mR)MW]for 0.5 sec. to transfer.+ “VF” appears briefly and VFOmode is selected.VFO mode selectedADVANCED FUNCTIONS 4© Memory/call = call/memory@ Select the memory/call channel to be transferred:=» Push [MR] (or [CALL]) to select memory (call) mode.‘» Rotate [DIAL] (or use the keypad) to select the memorychannel.@ While pushing and holding [FUNC] (until step @), push[(mA)MW] momentarily to indicate memory channels.“VF” appears and “i” flashes.* Do not hold [MW] for more than 0.5 sec., otherwise the memorychannel will overwrite the displayed number.@ Rotate [DIAL] to select a memory channel to transfer thedata.@ While continuing to push [FUNC], push [(mR)MW] for 0.5sec. to program.+ “(ill" stops flashing.© Memory clear® Push [MR] to select memory mode.® Select the memory channel to be cleared.® Push [FUNC] + [(vFo)M CL] for 0.5 sec.¢“.-----" appears briefly in place of the frequency, the memory iscleared and the next programmed memory is automatically se-lected.* Scan edges and memory channel 1 cannot be cleared.Y NOTE: Be careful — the contents of cleared memories“4CANNOT be recalled.NS