KERN KLB-TM Operating Manual

Contents

KERN KLB-TM Operating Manual Manual pdf 52 page image

For approx. 2 seconds appears „LOAD“ on the display, after that the defined valueof the correction point. With unloaded weighing plate, 0.000kg is shown in thedisplay.First look for that no load is on the weighing plate and the following symbols can beseen ( a, ), if not, press the a-button.Now put a defined weight on the weighing plate.After the weight display having been stabilized, press the PRINT-button in order toreach the next step.After the stabilization of the weight display at some models the next step isautomatically called up.The message „nEHt ?“ appears on the display. Now you must make up yourdecision if you want further linearization points.If you wish further linearization points, unload the weighing plate and subsequentlypress the PRINT-button, „Pnt2“ appears on the display (second linearization point).Now you must procede here as described aboce in „Pnt1“.The program allows to define up to 6 linearisation points. After having set the lastpoint (the 6th one), „DonE“ appears on the display and subsequently returns to themenu, on the display appears 0.L LinE .If less than 6 linearization points are necessary, press the F-button when themessage „nEHt ?“ appears, in order to finish the function and to return to theselection menu.In the display appears „donE“ and then 0.L LinE .Jumping back to the weighing mode saves the settings made.Notice:If after pressing the PRINT-button appears the „-LO-“ display for approx 2 seconds,followed by „donE“ and after that 0.L LinE, the function of the linearizationcorrection is locked.13.5 Factor for constant of gravitation P 0.A GcorThis correction factor is used to adapt the constant of gravitation for locations atdifferent degrees of latitude.This makes it possible to carry out adjustment at a different location than that wherethe display unit with connected weighing cell will later be operated.This factor is computed by applying the formula below:g (usage) / g (adjustment location) = g_corAllowable values range from 0.90000 to 1.10000.Notice: Is the display unit with connected weighing cell operated at the place ofadjustment, this factor is to be set at 1.00000.KLB-TM-BA-e-081152

/ 53

Related manuals for KERN KLB-TM