Kaba E-PLEX 2000 Operation Manual

Also see for E-PLEX 2000: Operation manual Installation instructions Installation instructions Quick reference guide

Contents

Kaba E-PLEX 2000 Operation Manual Manual pdf 12 page image

2322Procedure 12 - Activate/De-activate Passage ModeYou have already programmed a default duration for a door to remain inPassage Mode. When you enable Passage Mode, it becomes enabledfor the duration you have set in Procedure 5 - Program the Duration ofthe Passage Mode period, on page 9.If your length is 6 hours, and you enable Passage Mode at 1:00, it willautomatically re-lock at 7:00. Even if the lock was taken in and out ofPassage Mode multiple times during the six hour period, it will still re-lockafter six hours (programmable) from the original starting period. Thisensures that a lock will never remain in Passage Mode beyond theprogrammed time period.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 399# to activate / de-activate Passage Mode.3. Enter the code where 1 = activate PassageMode and 0 = de-activate Passage Mode.4. Example of Complete Entry to activate Passage Mode 399#1#.5. Enter another # to indicate the end of programming.6. You have now activated Passage Mode on the door.Procedure 13 - De-activate User Access CodesA User Code should be de-activated during a User’s vacation, for example,or if you created an Access Code but never assigned it to a User. Usercodes that are inactive, but might be needed some time in the future,should be de-activated rather than deleted.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 400# to de-activate User Access Codes.3. Enter the code 400 #NNN #, where NNN is the specific User IDlocation, 023 for example.4. Example of complete entry: 400 #023#.5. Enter another # to indicate the end of programming.6. You have now de-activated the User Access Code.5. Enter another # to indicate the end of programming.6. The Manager Access Code will now work in that door with all theaccess privileges assigned to a Manager User.Procedure 10 - Activate Service User Access CodeA Service User Access Code should be activated if it has been de-activated for a certain time period - during a Service User’s vacation, forexample, or if you created an Access Code but never assigned it to aService User.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 302# for Service User Functional Code.3. Enter the ID location NNN#, where NNN is the specific User IDlocation, 025 for example.4. Example of Complete Entry: 302#025#.5. Enter another # to indicate the end of programming.6. You have now activated a Service User Access Code.Procedure 11 - Activate All User Access CodesYou may need to activate all users if you have de-activated the wholegroup - after a lockout, for example. This procedure will re-activate allregular and Service User Access Codes that are not active.Required User Level: Master, Manager1. Put the lock into Pushbutton Programming Mode.2. Enter Command 398#.3. Example of Complete Entry: 398#.4. Enter another # to indicate the end of programming.5. You have now activated all regular User and Service UserAccess Codes.