305. Control Knobs5.2 EQ (EQUALIZER)The MP6 contains a three-band graphic equalizer to shape the overall tone ofthe sound. The EQ affects all zones at the same time. However, each SETUP canhave its own EQ setting that affects the internal sounds only.Be sure that the EQ button in the CONTROL KNOBS section is lit.If the EQ button is turned off, press it to turn it ON.The CONTROL KNOBS are now active and assigned to the EQ parameters. Usethe CONTROL KNOBS to change the current settings.Each parameter of the EQ has an adjustable range from -9 to +9. A positive (+)value indicates amplification, or a boost of that frequency range. A negative (-)value indicates attenuation, or a cut of that frequency range.The MFreq parameter has an adjustable range from 355Hz to 2500Hz.Lo, Mid, Hi -9 - +9MFrq (Hz) 355, 400, 450, 500, 560, 630, 710, 800, 900, 1000, 1120, 1250, 1400,1600, 1800, 2000, 2240, 2500Quick Change EQ OffsetPress and hold the EQ button. The EQ button starts blinking and the followingscreen for EQ Offset (see page 60) will be shown until the button is released.EQ Offset+0 -1 +9This parameter is stored automatically when leaving the screen, there is no needto store the setting manually.If EQ Offset is set to Off in System parameters, this page will not be displayed.Lo Mid MFrq Hi+9 -9 2240 +9Lo Mid MFrq Hi+9 -9 2240 +9
