356. MENU Buttons6.1 Editing Procedure and ParametersFirst, press the ZONE SELECT button for the zone to be edited.Next, press the MENU buttons until the parameter you want to edit appears inthe DISPLAY. When a zone is set as Both, pressing the ZONE SELECT button againwill switch the menu list from Internal to External or vice versa.Set the value of the parameter using the VALUE buttons.Since each parameter has a different value range, consult the following pagesfor the details. Repeat this procedure for any other parameters in any of thezones that need to be modified.Save these settings using the STORE button.(See page 53 for detail)Note:Once you enter the edit mode from SETUP mode by pressing the MENU button,the mode automatically changes to SOUND mode and the SOUND SELECT buttonsare used to select sounds, not SETUPs.You can exit the edit mode by pressing the EXIT(SW) button. Any edits you havemade so far will be retained to SOUND mode. If you exit the edit mode by pressingSOUND or SETUP buttons, your changes will be lost and the previously savedsettings are recalled.6.2 Edit ParametersZone parameters can be edited individually for each zone. There are twoparameter groups, Internal parameter group and External parameter group. Ifa zone is set to Int, only Internal parameters are available for editing. If a zone isset to Ext, only External parameters are available for editing. If a zone is set toBoth, both Internal and External parameters are available for editing.6.2.1 Zone ModeThis parameter sets the Zone mode. The example shows that the Zone 1 is setto Both mode.6.2.2 Sound (Int only)This parameter determines which internal sound is assigned for the selectedzone.1 Classic EPVel Comp. = 10Zone No. Sound NameParameter Value1 Classic EPVel Comp. = 10Zone No. Sound NameParameter Value1 Concert GrandSZone Mode =Both1 Concert GrandSZone Mode =Both1Internal Sound= Concert Grand1Internal Sound= Concert Grand