Kenwood DNX7180 Quick Start Manual

Also see for DNX5180: Service manual Instruction manual Brochure & specs Instruction manual Quick start guide

Contents

109Return to the Top pageAppendix●■ FCC WARNINGThis equipment may generate or use radiofrequency energy. Changes or modifications to thisequipment may cause harmful interference unlessthe modifications are expressly approved in theinstruction manual. The user could lose the authority tooperate this equipment if an unauthorized change ormodification is made.NOTEThis equipment has been tested and found tocomply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation.This equipment may cause harmful interference toradio communications, if it is not installed and usedin accordance with the instructions. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipmentoff and on, the user is encouraged to try to correctthe interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipmentand receiver.• Connect the equipment into an outlet on acircuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TVtechnician for help.DNX7180/DNX6980/DNX6180/DNX6040EX:●■ IC (Industry Canada) NoticeOperation is subject to the following two conditions:(1)This device may not cause interference, and(2)this device must accept any interference, includinginterference that may cause undesired operation ofthe device.The term “IC: ” before the certification/ registrationnumber only signifies that the Industry Canadatechnical specification were met.DNX7180:• Contains Transmitter ModuleFCC ID: RKXCK5050NEW• Contains Transmitter ModuleIC: 5119A-CK5050NEWDNX6980/DNX6180/DNX6040EX:• Contains Transmitter ModuleFCC ID: RKXCK5000NVIA• Contains Transmitter ModuleIC: 5119A-CK5000NVIADNX7180/DNX6980/DNX6180/DNX6040EX/DNX5180:2CAUTIONUse of controls or adjustments or performance ofprocedures other than those specified herein may resultin hazardous radiation exposure.In compliance with Federal Regulations, followingare reproductions of labels on, or inside the productrelating to laser product safety.Kenwood Corporation2967-3, ISHIKAWA-MACHI,HACHIOJI-SHITOKYO, JAPANKENWOOD CORP. CERTIFIES THISEQUIPMENT CONFORMS TO DHHSREGULATIONS NO.21 CFR 1040. 10,CHAPTER 1, SUBCHAPTER J.Location: Top plateDNX7480BT/DNX6480BT:●■ The marking of products using lasersCLASS 1LASER PRODUCTThe label is attached to the chassis/case and saysthat the component uses laser beams that have beenclassified as Class 1. It means that the unit is utilizinglaser beams that are of a weaker class. There is nodanger of hazardous radiation outside the unit.●■ CALIFORNIA, USAThis product contains a CR Coin Cell Lithium Batterywhich contains Perchlorate Material – special handlingmay apply.See www.dtsc.ca.gov/hazardouswaste/perchlorate.