Kenwood KDC-MP8533 Instruction Manual

10 | EnglishGeneral featuresSystem QSelecting the best sound setting preset fordifferent types of music.1 Select the source to adjustPress the [SRC] button.2 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "SYS.Q" isdisplayed above the [1] button.Refer to (page 8).3 Enter System Q modePress the [1] ("SYS.Q") button.4 Select the Sound typePush the Control knob towards [4] or[¢].Each time the knob is pushed, the settingswitches as shown below.Sound setting DisplayUser memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP 40"Jazz "JAZZ"Natural "NATURAL"• User memory:The values set on the

• Change each setting value with the Setting> (page 12).First, select the speaker type with the Speaker setting.Audio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Basic Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Basic Audio itemTurn the [VOL] knob.Adjustment Item Display RangeRear Volume * 1 "Rear Volume" 0 — 35Subwoofer level*2,3 "Sub-W Level" –15 — +15Bass level* 4 "Bass Level" –8 — +8Middle level* 4 "Middle Level" –8 — +8Treble level* 4 "Treble Level" –8 — +8Balance "Balance" Left 15 — Right 15Fader*3 "Fader" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)• *1 You can control this item when "2 ZONE" of Setup> (page 12) is set to "ON".• *2 You can control this item when Output> (page 12) is set to "SW ON".• *3 You can control this item when "2 ZONE" of Setup> (page 12) is set to "OFF".• *4 You can adjust these items in detail. Refer to(Page 11).• *4 Source tone memory: Puts the set up value in thememory per source. (Detail Audio item is included)5 Exit Audio Control modePress any button.Press a button other than the [VOL] knob, [ANG]and [ATT] button.