Kenwood KDC-MP8533 Instruction Manual

12 | EnglishGeneral featuresAudio SetupSetting the Sound system, such as Cross overNetwork.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeFront High Pass Filter*2 "HPF-F Fc" Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter* 2 "HPF-R Fc" Through/40/60/80/100/120/150/180/220 HzLow Pass Filter*1,2 "LPF-SW" 50/60/80/100/120/Through HzSubwoofer Phase*1,2,3 "SW Phase" Reverse (180°)/ Normal (0°)Volume offset "Vol-Offset" –8 — ±0Loudness "LOUD" OFF/ONDual Zone System "2 ZONE" OFF/ON• Volume offset: Sets each source’s volume as adifference from the basic volume.• Loudness: Compensates for low and high tonesduring low volume.• *1 You can control this item when Output> (page 12) is set to "SW ON".• * 2 You can control this item when "2 ZONE" of Setup> (page 12) is set to "OFF".• * 3 You can control this item when Low Pass Filter is notset to Through.• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 30).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by Control> (page 10).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the Auxiliaryinput sources listed below.- Internal auxiliary input5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob."SP SEL" is displayed.3 Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the settingalternates between the settings shown in thetable below.Speaker type DisplayOFF "OFF"For 5 & 4 in. speaker "5/4 inch"For 6 & 6x9 in. speaker "6x9/6 inch"For the OEM speaker "O.E.M."4 Exit Speaker Setting modePress the [VOL] knob.Subwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward [AM] for atleast 2 seconds.Each time you press the button, Subwooferoutput switches ON and OFF.When it is ON, "SW ON" is displayed.• You can control this function when "2 ZONE" of