Kenwood KDC-MP8533 Instruction Manual

English | 15Display Mode Display"Display Type A" 1"Display Type B" 1 2"Display Type C" 433 53 6"Display Type D" 4 768 8 8 8 8 81 Graphic display part2 Text display part3 Text icon display part4 Upper text display part5 Middle text display part6 Lower text display part7 Source icon display part8 Function item display5 Exit display control modePress the [6] ("RTN") button.• Under the display type other than "Display Type D",the function item is not displayed. When you selectthe display type other than "Display Type D", press [1]to [6] buttons or [NEXT] button. The function item willbe displayed approximately 5 seconds.• The indicator is displayed when the display type is setto "Display Type C" or "Display Type D".• Change the information by the Display Type. Refer tothe page on the following table for the methods toalternate by the Display Type.Display Type A B C DGraphic 1 15 15 — —Text 2 — 16 — —Upper 4 — — 17 17Middle 5 — — 18 —Lower 6 — — 18 18Display Type A/ Display Type BGraphic part Display SwitchingChanging the graphic Display.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [2] button.Refer to (page 8).2 Enter display control modePress the [2] ("DISP") button.3 Select the display modePress the [1] ("MODE") button.4 Select the display TypePush the Control knob towards [4] or[¢].Select the "Display Type A"/ "Display Type B"display.5 Select the graphic displayPress the [3] ("Graph") button.6 Select the graphic part displayPush the Control knob towards [4] or[¢].Each time you press the button, the graphicdisplay alternates between the displays shown inthe table below.Graphic displayMovie 1Movie 2Wallpaper7 Exit display control modePress the [6] ("RTN") button.• The setting of this function is available while "DisplayType A"/ "Display Type B" is selected for the Displaymode.