English|35Other than Standby modeAudio Preset RecallRecalling the sound setup registered by Preset Memory> (page 34).1Select the sourcePress the [SRC] button.Refer to (page 7).2Enter Menu modeUsing the Control knob, select "MENU".For the operation method, refer to Control mode> (page 10)."MENU" is displayed.3Select Audio Preset modeTurn the Control knob.Select the "Audio Preset" display.4Enter Audio Preset modePress the Control knob for at least 1 second.5Select the Audio Preset RecallTurn the Control knob.Select the "Recall" display.6Determine whether to recall the Audio PresetPress the Control knob."Recall?" is displayed.7Recall the Audio PresetSelect "Yes" using the Control knob."Recall Completed" is displayed.8Exit Audio Preset modePress the [FNC] button.⁄• The User memory of "SYSTEM Q" in (page 8) is changed to the value which was recalled.• The source tone memory item of 8) is changed to the value which was recalled by theselected source.Function of KDC-W7537U/KDC-W7537UYIn Standby modeFirmware version displayDisplaying the firmware version with the unit.Turn the Control knob.Select the "F/W Version : " display.In Standby modeDemonstration mode SettingSets the demonstration mode.1Select the Demonstration modeTurn the Control knob.Select the "DEMO Mode" display.2Set the Demonstration modePress the Control knob for at least 2 seconds.Each time you press the knob at least 2 seconds,the Demonstration mode alternates between thesettings shown in the table below.DisplaySetting"DEMO Mode : ON"The Demonstration mode function is ON."DEMO Mode : OFF"Exit Demonstration mode (Normal mode).
