English|9• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 30).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by (page 8).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the internalauxiliary input.5Exit Audio Setup modePress the [VOL] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1Enter StandbyPress the [SRC] button.Select the "STANDBY" display.Refer to (page 7).2Enter Speaker Setting modePress the [VOL] knob."SP SEL" is displayed.3Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the setting alternatesbetween the settings shown in the table below.Speaker typeDisplayOFF"OFF"For 5 & 4 in. speaker"5/4inch"For 6 & 6x9 in. speaker"6x9/6inch"For the OEM speaker"O.E.M."4Exit Speaker Setting modePress the [VOL] knob.Subwoofer OutputTurning the Subwoofer output ON or OFF.Push the Control knob toward down for at least2 seconds.Each time you push the knob, Subwoofer outputswitches ON and OFF.When it is ON, "SUB WOOFER ON" is displayed.TEL MuteThe audio system automatically mutes when a callcomes in.When a call comes in"CALL" is displayed.The audio system pauses.Listening to the audio during a callPress the [SRC] button.The "CALL" display disappears and the audio systemcomes back ON.When the call endsHang up the phone.The "CALL" display disappears and the audio systemcomes back ON.⁄• To use the TEL Mute feature, you need to hook upthe MUTE wire to your telephone using a commercialtelephone accessory. Refer to Terminals> (page 39).
