Kenwood KDC-W7037 Instruction Manual

Kenwood KDC-W7037 Instruction Manual Manual pdf 41 page image

InstallationFirewall or metal supportScrew (M4X8)(commercially available)Self-tapping screw(commercially available)Metal mounting strap(commercially available)Bend the tabs of themounting sleeve with ascrewdriver or similar utensiland attach it in place.⁄• Make sure that the unit is installed securely in place. If theunit is unstable, it may malfunction (for example, the soundmay skip).Installation/Removing the UnitScrewing the Faceplate on the UnitIf you want to fasten the faceplate to the main unitso that it does not fall off.1 Refer to the section frame> and then remove the hard rubber frame.2 Drop open the faceplate by pressing the Releasebutton.3 Tighten the screw (ø2 × 5 mm) (Accessory 4) andbracket (Accessory 5 ) in the hole shown on thediagram.Accessory4Accessory54 Tighten the screw (ø2 × 5 mm) (Accessory 4) andbracket (Accessory 6) in the hole shown on thediagram.Accessory4Accessory6¤• Never insert the screws in any other screw hole than theone specified. If you screw them in another hole, it willcontact and may cause damage to the mechanical partsinside the unit.English | 41