Kenwood KDC-X891 Instruction Manual

Also see for KDC-X891: Firmware update guide Installation manual Instruction manual

English | 11Display Type SelectionChanging the display mode.1 Enter Display Type Selection modeUsing the Control knob, select "DISP" > "TYPE".For the operation method, refer to Control mode> (page 10).2 Select the display TypeTurn the Control knob.Select from the following display types:Display Mode Display"TYPE SELECT [A]"12"TYPE SELECT [B]"123"TYPE SELECT [C]"6254000"TYPE SELECT [D]"!6254"TYPE SELECT [E]"827"TYPE SELECT [F]"91 Graphic display part2 Status display3 Text display part4 Upper text display part5 Middle text display part6 Lower text display part7 Text display part8 Graphic display part9 G-Analyzer display part0 Text icon display part! Source icon display part3 Exit Display Type Selection modePress the Control knob.⁄• To change the information by the Display Type, referto the page on the following table for the methods toalternate by the Display Type.Display Type A B C D E FGraphic 1 12 12 — — — —Status 2 11 11 — — — —Text 3 — 12 — — — —Upper 4 — — 13 13 — —Middle 5 — — 13 13 — —Lower 6 — — 13 13 — —Text 7 — — — — 12 —G-Analyzer 9 — — — — — 15Display Type A/ Display Type BStatus SettingDetermine whether the On and Off statuses ofvarious functions are to be displayed on the DisplayType A/B.1 Enter Status Setting modeUsing the Control knob, select "DISP" >"STATUS".For the operation method, refer to Control mode> (page 10).2 Select the Status displayTurn the Control knob.3 Exit Status Setting modePress the Control knob.