English | 31Category and Channel SearchSelecting the channel and category you want toreceive.1 Enter Category and Channel Search modePress the Control knob.2 Select the CategoryPush the Control knob towards up or down.⁄• It is the item when the category of Middle text displaypart is selected.3 Select the ChannelPush the Control knob towards [4] or [¢].⁄• You cannot Channel search until the categoryinformation is acquired.Cancelling Category and Channel Search modePress the Control knob.Function of remote controlDirect Access TuningEntering the channel and tuning.1 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol.2 Enter the channelPress the number buttons.3 Do Channel SearchPush the Control knob towards [4] or [¢].Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• If you make no button operation for 10 seconds, theDirect Access Tuning mode is automatically canceled.• If you cannot receive any signal in the input Channel dueto bad conditions on radio wave or other such problems,"Acquiring Signal" appears.Selecting the Preset BandPush the Control knob toward [FM].Each time you push the knob, the preset bandalternates between the SR1, SR2, SR3 and SR4.Channel Preset MemoryPutting the channel in the memory.1 Select the preset bandPush the Control knob toward [FM].2 Select the channel to put in the memoryPush the Control knob towards [4] or [¢].3 Enter Preset Memory modeUsing the Control knob, select "P.MEM".For the operation method, refer to Control mode> (page 10).4 Select the number to put in the memoryTurn the Control knob.5 Determine the number to put in the memoryPress the Control knob.6 Allow the determined number to take effectPress the Control knob.Cancelling the Preset Memory modePress the [FNC] button.⁄• Only the channel number is stored. Category informationis not stored.