18 EnglishSpeaker settingsSpeaker setup ("SP SETUP")This sets up the speakers according to the speaker system inuse. Speaker setup is required every time the speaker system ischanged.œ See (&) andselect "SP SETUP".∑ Use [MULTI CONTROL 5/∞] to select the subwoofersetting.Speaker Display SelectionSubwoofer "SUBW ON" With Subwoofer"SUBW OFF" Without Subwooferé Press [SETUP].® Repeat steps ∑ – é for the rest of the speakersetting.Speaker Display SelectionFront speaker "FRNT LRG" Large size front speaker"FRNT NML" Average size front speakerCenter speaker"CNTR NML" Average size center speaker"CNTR LRG" Large size center speaker"CNTR OFF" No center speaker is connected.Surround speaker"SURR NML" Average size surround speaker"SURR LRG" Large size surround speaker"SURR OFF" No surround speaker is connected.Subwoofer re-mix* "RMX ON" Subwoofer re-mix is on."RMX OFF" Subwoofer re-mix is off.* The function for adding the bass of other channels to thesubwoofer channel according to the speaker setup.† Go to the next setting, "TEST TONE".• If you wish to exit the setup mode, see &.Notes:• When "SUBW OFF" is selected, the front speakers areautomatically set to "FRNT LRG".• For "FRNT LRG" selection, no sound will be heard from subwoofereven it is set to ON. However, if you select "RMX ON", you will beable to hear sound from the subwoofer.• When in STEREO mode, the sound goes directly to front speakers.• If "FRNT NML" is selected, "CNTR LRG" cannot be selected.• If "CNTR NML" or "CNTR OFF" is selected, "SURR LRG" cannot beselected.Adjusting the speaker level("TEST TONE")From your usual listening position, adjust the volume output ofeach speaker. The output level from each speaker should be thesame.œ See (&) andselect "TEST TONE".∑ Use [MULTI CONTROL 5/∞] to select either "AUTO"or "MANUAL".Display Selection"AUTO" The test tone is heard from the speakers one after another with2 seconds each."MANUAL" The test tone is heard from the speaker you have selected.é Press [SETUP].® Adjust the output level.If you select "AUTO":When you hear the test tone from the speaker whichyou wish to adjust, use [MULTI CONTROL 5/∞] andadjust the volume of the test tone. When you finishadjusting, press [SETUP].If you select "MANUAL":Use [MULTI CONTROL 5/∞] to adjust the volume ofthe test tone and press [SETUP]. You will hear thetest tone from the next speaker.† Go to the next setting, "DISTANCE".• If you wish to exit the setup mode, see &.