Kenwood KRF-V5200D Instruction Manual

Also see for KRF-V5200D: Service manual

English 19Distance setting ("DISTANCE")This sets the distance from each speaker to the listening position.œ Measure the distance from the listening position toeach speaker and jot down in the table below.Speaker Indicator Distance from the listeningpositionFront speaker (left) "L" feet (meters)Center speaker "C" feet (meters)Front speaker (right) "R" feet (meters)Surround speaker (right) "RS" feet (meters)Surround speaker (left) "LS" feet (meters)Subwoofer "SW" feet (meters)∑ See (&) andselect "DISTANCE".é Use [MULTI CONTROL 5/∞] to select the distanceto the front speaker.• Adjustment will start from front left speaker.Indicator® Press [SETUP].† Repeat steps é – ® to input the distance for therest of the speaker.¥ Go to the next setting, "LFE LVL".• If you wish to exit the setup mode, see &.Low frequency effects level ("LFELVL")Low frequency effect signal is used exclusively for giving the fieldeffect of bass tone in the Dolby Digital and DTS signal.œ See (&) andselect "LFE LVL".∑ Use [MULTI CONTROL 5/∞] to adjust the lowfrequency effect level.• The level is adjusted from 0dB to -10dB in 1dB step decrements.é Press [SETUP].• The setup is complete when the "EXIT" indication appears.® Press [SETUP] to exit the setup mode.