Kenwood KRF-X9070D Instruction Manual

Also see for KRF-X9070D: Service manual Instruction manual Instruction manual

Contents

Kenwood KRF-X9070D Instruction Manual Manual pdf 26 page image

26 ENNormal playbackThe indicator for the speakersyou want to use should be lit.Preparing for playbackSome preparatory steps are needed before starting playback.INPUT MODEMD/TAPESPEAKERSPOWERON/STANDBY(VR-7080)ON/STANDBY(KRF-X9070D)POWER ON/OFF(KRF-X9070D)Turning on the receiver1 Turn on the power to the related components.2 Turn on the power to this receiver by pressing the POWERON/STANDBY key.Selecting the input modeIf you have selected a component connected to the CD/DVD, VIDEO2, VIDEO 3 or DVD/6CH jacks, make sure that the input mode settingis correct for the type of audio signal to be used. 0Selecting MD/TAPESelect the source name corresponding to the component connectedto the MD/TAPE jacks. The initial factory setting is “TAPE”. Tochange the source to “MD”, follow the steps below:Hold down the MD/TAPE key for more than 2 seconds.• The source indication changes to “MD”.• To return to the original indication, repeat the above procedure.Selecting the speaker systemPress the SPEAKERS key to select the speaker system to beused.A ON : Sound from the speakers connected to the SPEAKERS Aterminals on the rear panel.B ON : Sound from the speakers connected to the SPEAKERS Bterminals on the rear panel. No sound will be heard fromthe subwoofer.A+B ON : Sound from both the speakers connected to theSPEAKERS A and B terminals on the rear panel.A+B OFF : No sound from the speakers. Use this setting whenlistening with headphones for stereo sound in all playbackmodes. The display segments are different depending onthe type of input signal.LSL S SB SRC RSP MUTE OPTICAL 6CH INPUTCOAXIAL ANALOG 96kHzfsCINACTDSA B CLIPAUTO DETECTSWLFE• Selecting “6CH INPUT” by pressing the INPUT MODE key, whereby“DVD/6CH” is the input source will cause SPEAKERS A to be selectedautomatically.Listening to a source componentPTYVOLUME CONTROLVOL %/fiInput SelectorInput Selector AV AUX1Use the Input Selector and AV AUX key to select thesource you want to listen to.Selecting a source using each key.1 “DVD/6CH”2 “CD/DVD”3 “PHONO”4 “TUNER”5 “VIDEO 1”6 “VIDEO 2”7 “VIDEO 3”8 “MD/TAPE”9 “AV AUX”2Start playback from the selected source.3Use the VOLUME CONTROL knob or VOL %/ fikeys toadjust the volume.