Kenwood KRF-X9070D Instruction Manual

Also see for KRF-X9070D: Service manual Instruction manual Instruction manual

Contents

Kenwood KRF-X9070D Instruction Manual Manual pdf 42 page image

42 ENBasic remote control operations for other componentsLEARNMULTISOUNDPTYSRCPWR C. SEARCH DIRECTOSD RETURNMEMORYTV MUTETUNE +BANDTUNE –M. ZONELANG.AUTODIMMERINFO. / DISP. TV / SATLAST CH.AMESEEKFLIPDISC SEL.INPUT SEL.DISC SKIPEXITGUIDE+ 100 + 10BYPASS A / B812 73 694 50P.CALLP.CALLTOP MENU MENUCHPAGEInfrared ray system part5Press the desired key on the remote control unit.6From the remote control of the other component, press the keywhich you want to store.• If the process is successful, the IR indicator will blink twice. Repeatfrom step 2 onwards up to the limit of the memory.• If the code cannot be stored, the IR indicator will display one longblink. Try again by repeating from step 2 onwards.7The remote control code of the other component is stored onthe key of this remote control unit.8Repeat steps 4to 7to store additional components until allthe desired components are stored.9Press the LEARN key again to exit the learning mode.0To clear the stored remote control code of the othercomponents :1 Press and hold the LEARN key for 3 seconds until the IRindicator blinks twice, then release the LEARN key.2 Press the Numeric keys to enter "9 - 7 - 6".• The IR indicator will blink twice as confirmation.3 Press the Source key, then press the stored key twice.• The IR indicator will blink twice as confirmation.Note• Be sure to point the remote control at the remote sensor on the receiverwhen you want to operate KENWOOD components connected bysystem control cords. Otherwise, point the remote control at thecomponent you want to operate.Storing the remote control code of the othercomponentsThis remote control unit can store the remote control code of the othercomponents and you can operate the other components from thisremote control unit. The remote control code is stored on the key ormemory of this remote control unit.Storing on the keysYou can store the remote control code of the other components to thesekeys as shown below:1Point the infrared ray system part of the other component’sremote control unit to the IR indicator of this remote controlunit.• This remote control is ready to receive the remote control code ofthe other component.2Press and hold the LEARN key for 3 seconds until the IRindicator blinks twice, then release the LEARN key.3Press the Numeric keys to enter "9 - 7 - 5".• The IR indicator will blink twice as confirmation.4Press any of the Source keys (DVD/6CH, CD/DVD, VIDEO1,VIDEO2, VIDEO3, MD/TAPE, TV, AV AUX, PHONO) to select theinput of the desired remote control unit.• When in Tuner mode, learning code function will not be available.Remote controlunit of the othercomponentPTY