4 Memory ContentsEach memory channel can store information asshown in the chart below.X =Can be stored in memoryNormal SplitChannel ChannelRX frequencyTX frequencyTone(CTCSS) frequency,Tone (CTCSS) statusFrequency stepShift status, REV on/off X N / ADTSS code. DTSS status X X5 Entering Memory DataEntering memory data is a simple operation requiringjust a few keystrokes to store all the data yourequire.Entering Normal Simplex/RepeaterChannels1 Select the desired receive frequency, offset, and anyother information you desire. If the desiredfrequency is already on the display, continue to step2.2 Press the M key. The memory indicator will flash.3 Use the keypad to select any desired memorychannel number (O-49). Use a two-digit number,such as 02 for channel 2 or 15 for channel 15, toenter the data in memory.4 Press the MR key.5 The memory channel number will turn off, indicatingthat the receiver data has been properly stored.Clearing a Memory ChannelUse the following procedure to clear the contents ofan individual memory channel:1 Select the memory channel to be cleared.2 Press the M key for longer than one second, thenpress the MR key.3 The selected memory channel number is removedfrom the display and the data is cleared from thememory.