Kenwood TH-78A Instruction Manual

Also see for TH-78A: Instruction manual Instruction manual Service manual Instructions Instruction manual

Contents

POWER ON MESSAGE AND FUNCTION MESSAGE1 Power On MessageWhen you first switch the POWER on, “TH78A” or“TH78E” appears on the display for two seconds.You can change this factory-set message to yourown message as follows:Changing Power-on Message2 Function MessageWhen you select a function, the correspondingfunction message is displayed on the LCD for twoseconds.The message and functions are listed below.1 Select your message by following steps 1 to 4 of thememory write procedure on page 44.2 Press the 0 key.The power-on message has now been changed. Ifyou switch the power off and on again, your ownmessage will be displayed on the display for twoseconds.j NOTEThe above message, which is stored in messagememory channel 0, appears each time you switchthe power on.Message FunctionAF CHGAF INIAF MIXAF SEPAS OFFAS ONBELL 1BELL 2BP OFFBP ONDTMF0SDTMF2STranspose the two AF bandsInitial AF output settingMix the AF output from both bandsSeparate the AF output into two bandsAutomatic offsets OFFAutomatic offsets ONTone alert (Telephone type ring)Tone alert (Tone alarm)Beep OFFBeep ONNo DTMF signal transmission delay timeSetting DTMF signal transmission delay time(two seconds)57