5 Press and hold the M key for longer than onesecond, then press the 4 key.Notes1 Initialize the VFO memory (VFO RESET) to clearboth programmed limits simultaneously. Pressand hold the F key and turn on the power. Youcan reprogram either limit independently.Initiating Programmable Band Scan1 Adjust the SQL control to the threshold point.2 Select a frequency between the two programmedscan limits.2 Programmable band scan is not initiated whenthe lower frequency limit is not in the same bandor step size, or when it is higher than the upperlimit frequency.Confirming Scan Limit* Press the F key for longer than one second, thenpress the 4 key to display the band scan lowerfrequency limit.n Press the F key for longer than one second, thenpress the 5 key to display the band scan upperfrequency limit.3 Press and hold the VFO key for longer than onesecond.The MHz indicator will flash when the transceiver isscanning.7 MHz Scan1 Adjust the SQL control to the threshold point.2 Start the band scan or programmable band scan.3 Press the MHz key during band scan orprogrammable band scan. Scanning begins in anupward sequence over a 1 MHz range.Example: If the MHz key is pressed when thefrequency is 145.02 MHz for VHF band scan, just the145 MHz band is scanned.8 VFO/Memory ScanThis function lets you alternately scan the VFOfrequency shown on the display and the last-usedmemory channel.1 Adjust the SQL control to the threshold point.27