Kenwood TH-78A Instruction Manual

Also see for TH-78A: Instruction manual Instruction manual Service manual Instructions Instruction manual

Contents

Notes on simultaneous in Band reception1 When two signals on the same band arereceived simultaneously, the receiveperformance, such as image interferenceand sensitivity, may be reduced.2 If the two frequencies are the same, thevolume may decrease at some VOL controlpositions.To return to normal operation press the f² key again.10 Single Band OperationWhen you press the DUAL key, the band for whichthe PTT indicator is on is selected, and you canperform a single-band operation with that band.When you press the BAND key, the band in thesingle-band operation changes.Each time you press the DUAL key, you togglebetween single-band and dual-band operation.11 MHz ModeIf you use this function, you can change thefrequency in l-MHz steps.Press the MHz key.The 100-kHz digit and lower digits of the operationband go blank. When you turn the tuning control,the frequency changes in l-MHz steps.To return to the normal frequency display, press anyfront panel key (except E.CHG key) or wait 10seconds.12 Channelized Frequency DisplayThe frequency display can be changed to displaychannel numbers instead of the operating frequency.This function makes use of the data you have storedin memory for this function. Channel 1 is memorychannel 1, Channel 2 is memory channel 2, etc.1 Turn the POWER switch off.2 Press and hold down the 3 key, then press thePOWER switch.Channel number are displayed for both bands3 The channel number can be changed with the tuningcontrol.4 To return to the normal frequency display, performsteps 1 and 2 again.52