Kenwood TK-5710 Series Instruction Manual

Also see for UHF P25 Transceiver TK-5810: Instruction manual Specifications Service manual Instruction manual Brochure & specs

4receiving1 Select the desired zone and channel using the GRP and keys and theCH control.2 When you hear a caller’s voice, readjust the volume as necessary.• If signaling has been programmed on the selected channel, you will hear a call onlyif the signal tone matches the tone set up on your transceiver.Note: Signaling allows your transceiver to code your calls. This will prevent you from listeningto unwanted calls. It does not make calls private, it only prevents them from being heard bytransceivers set with a different signaling code. Refer to “SIGNALING” on page 28 for details.■ Receiving Group Calls (P25)When you receive a group call on a Conventional channel and the receivedgroup ID matches the ID set up on your transceiver, you can hear the caller’svoice.When you receive a group call on a Trunking channel, the transceiverautomatically switches to the traffic channel to receive the call.• Readjust the volume as necessary.■ Receiving Individual Calls (P25)When you receive an individual call on a Conventional channel, a ringing tonewill sound and the display will show the caller’s ID. To respond to the call,press and hold the microphone PTT switch and speak into the transceiver asyou would during a normal transmission.When you receive an individual call on a Trunking channel, a ringing tone willwound and the display will alternate between the caller’s ID and “RECEIVING”.To receive the call, press the PTT switch. To deny the call, press and hold thePF 1 key or the DTMF # key. After receiving the call, you can respond to thecall by pressing and holding the PTT switch and speaking into the microphoneas you would during a normal transmission. After the call is finished, press thePF 1 key or the DTMF # key to end the call.