Kenwood TK-5710 Series Instruction Manual

Also see for UHF P25 Transceiver TK-5810: Instruction manual Specifications Service manual Instruction manual Brochure & specs

36buSy chAnnel locKouT (bcl)If set up by your dealer, you will be unable to transmit on a conventional channelif it is already in use. Under these circumstances, use a different channel or waituntil the channel becomes free.However, if BCL Override has also been programmed, you can transmit overtopof the current signal:1 Press and hold the microphone PTT switch.• If the channel is already in use, a warning tone will sound.2 Release the microphone PTT switch, then press and hold the microphone PTTswitch again within half a second.3 Speak into the transceiver as you would during a normal transmission.ouT oF rAngeOn Trunking channels, if set up by your dealer, the transceiver will indicate when itis out of range. When it can no longer communicate with any site, an out of rangetone sounds and “OUT OF RANGE” appears on the display.SiTe TrunKingOn Trunking channels, if set up by your dealer, the transceiver will indicate anetwork condition on the registered site. When the transceiver receives a networkdisabled message, “SITE TRUNK” appears on the display.conTrol chAnnel hunTOn Trunking channels, the transceiver must search for a control channel. Whilesearching for a control channel, no signals can be received. The search beginsautomatically when you change to a Trunking channel.pTT idPTT ID is a unique transceiver ID code which is sent each time the microphonePTT switch is pressed.Note: PTT ID can be made only in FM Operation.If Beginning of Transmit is set, the ID signal is transmitted when you press themicrophone PTT switch.If End of Transmit is set, the ID signal is transmitted when you release themicrophone PTT switch.If both are set, the ID signal is transmitted when you press and release themicrophone PTT switch.

/ 44

Related manuals for Kenwood UHF P25 Transceiver TK-5810