Kenwood TK-5710 Service Manual

Also see for TK-5710(H): Instruction manual Specifications Instruction manual Instruction manual Instruction manual

5TK-5710(B)/5710H(B)REALIGNMENT1. Modes 2. How to Enter Each ModeMode OperationUser mode Power ONPanel test mode [PF1] + Power ONPC mode Received commands from PCPanel tuning mode [Panel test mode] + [GRP^]Firmware programming mode [PF2] + Power ONClone mode [PF5] + Power ONSelf programming mode [GRP^] + Power ONFirmware version information [PF3] + Power ONClock adjustment mode [PF4] + Power ON3. Panel Test ModeSetting method refer to ADJUSTMENT.4. Panel Tuning ModeSetting method refer to ADJUSTMENT.5. PC Mode5-1. PrefaceThe transceiver is programmed by using a personal com-puter, programming interface (KPG-43) and programmingsoftware (KPG-95D).The programming software can be used with an IBM PCor compatible. Figure 1 shows the setup of an IBM PC forprogramming.User modePanel test modeFirmware version informationPanel tuning modeData programming modePC test mode PC tuning modePC modeClone modeFirmwareprogramming modeClock adjustment modeSelf programming modeMode FunctionUser mode For normal use.Panel test mode Used by the dealer to check the fundamen-tal characteristics.Panel tuning mode Used by the dealer to tune the transceiver.PC mode Used for communication between thetransceiver and PC (IBM compatible).Data programming Used to read and write frequency data andmode other features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.See panel tuning.Firmware Used when changing the main program ofprogramming mode the flash memory.Clone mode Used to transfer programming data fromone transceiver to another.Self programming You can program the frequency,mode signaling and other functions using only thetransceiver.Firmware version Used to confirm the internal firmwareinformation version.Clock adjustment Used by the dealer to adjust date and time.mode Fig. 1IBM-PCKPG-43KPG-95D5-2. Connection procedure1. Connect the transceiver to the personal computer withthe interface cable.2. When the POWER switch on, user mode can be enteredimmediately. When PC sends command the transceiverenter PC mode, and “PROGRAM” is displayed on theLCD.When data transmitting from transceiver, the red LED islights.