17■ I DENTIFICATION C ODESAn ID code is a combination of a 3-digit Fleet number and a 4-digit IDnumber. Each transceiver must have its own Fleet and ID number.• Enter a Fleet number (100 ~ 349) to make a group call.• Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.• Enter a Fleet number make a call to all units in the selected fleet (Interfleet call).• Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).• Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).Note: The ID range may be limited by programming.STATUS M ESSAGEYou can send and receive 2-digit Status messages which may be decided in yourtalk group. Messages can contain up to 16 alphanumeric characters. Statusmessages range from 10 to 99 (80 ~ 99 are reserved for special messages).A maximum of 15 received messages can be stored in the stack memory of yourtransceiver. These saved messages can be reviewed after reception.Depending on your dealer settings, when the stack memory is full, either theoldest message will be erased when a new message is received or the newmessage will not be stored in the stack memory. The icon lights when amessage is stored in the stack memory.■ T RANSMITTING1 Select your desired zone and group (or zone and channel).2 Press the key programmed as Status to enter Status Mode or Selcall +Status to enter Selcall Mode.• When using the Status key to enter Status Mode, the target Fleet/ ID is fixedand cannot be selected. Skip to step 5 to continue.3 In Selcall Mode, press the and C> keys to select the ID of the stationyou want to call.• If programmed by your dealer, you can also use the and keys.• If Manual Dialing is enabled, you can enter digits by using an optional DTMFkeypad or by selecting digits with the and keys. When using the andkeys, cycle through the digits to select a digit, then press the C> key toaccept the digit and shift the cursor to the right. Repeat this process until theentire ID is entered.4 Press the S key to enter Status Mode.5 Press the and C> keys to select the status ID you want to transmit.• If programmed by your dealer, you can also use the and keys.• If Manual Dialing is enabled, you can enter digits by using an optional DTMFkeypad or by selecting digits with the and keys. To enter manual inputmode, first press and hold the S key. When using the and keys, cyclethrough the digits to select a digit, then press the C> key to accept the digit andshift the cursor to the right. Repeat this process until the entire ID is entered.6 Press the PTT switch or ■ key to initiate the Status call.• “COMPLETE” is displayed when the call has been successfully transmitted.