D-54 APPENDIX D General Setup, Configuration and TroubleshootingSeries 5000 Sonar System Operations and Maintenance Manual P/N 11210060, Rev. 13.0D.9 Software TroubleshootingIf for some reason SonarPro will not open, or SonarPro gets saved in somecorrupted condition and will not operate, you can recover to the default installationcondition by editing the operating system’s Registry.To edit the registry:1. Select Start/Run, enter REGEDT in the Open text box, and then click OK.2. Navigate the path My Computer/HKEY_CURRENT_USER/Software/KleinAssociates.3. Select and then delete SonarPro.4. Start SonarPro, and then select New State from the Session Menu.To totally remove C-Maps from the registry:1. Select Start/Run, enter REGEDT in the Open text box, and then click OK.2. Navigate the path My Computer/HKEY_CURRENT_USER/Software.3. Select and delete C-Map.4. Navigate the path My Computer/HKEY_LOCAL_MACHINE/Software.5. Select and delete C-Map.6. Select and delete Aladin.D.10 Terminating an Optical FiberWhen terminating optical fibers, use a termination kit such as the FotecFiber-Optic Termination Kit.To terminate an optical fiber:1. Plug oven in.2. Place a piece of tape on the table to catch the fiber when cut.3. Mix epoxy.4. Put epoxy into the syringe.5. Slide the strain relief over the fiber.WARNING Safety glasses should be worn when handling optical fiber. Inaddition, when handling broken fiber, use extreme caution as the fiber caneasily penetrate clothing and skin causing injury and infection.
