Installation and Relocation 2-72.3.1 Install the softwareThe following procedure describes installation of Client (Only) software. Forinformation on installing Client + Server software, refer to the Labcyte EchoIntegration Guide.To install Echo liquid handler software:1. Insert the Echo liquid handler software installation CD into the CD drive.The installation should automatically start.If the installation does not start:a. Go to My Computer and double-click the drive icon for the CD drive.b. Look for setup.exe in the directory on the CD and double-click theicon.c. Select Install Client (Only)2. Enter the Host Name or IP address that will be used by the Echo server.The Echo liquid handler comes pre-configured with IP address192.168.1.1 and a subnet mask of 255.255.0.0. If you cannot use this IPaddress, run the Echo Admin Client on the Echo Server 2.4 disk to entera different IP address.Figure 2.3 Entering host name
