6 ENINTRODUCTION Attaching the StandYou must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.Note:• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,resulting in injuries as well as damage to the unit.• Make sure to use a table which can support the weight of this unit and is larger than this unit.• Make sure the table is in a stable location. Supplied Accessories1 Spread a thick and soft cloth over atable as shown below.Place the main unit face down onto it.Make sure not to damage the screen.At least two people are required atthis step.2 Align the 2 stand hooks with the twohooks under the bottom of the mainunit (shown by arrow ➀), then slidethe stand in the direction as shownby arrow ➁ until it stops and the 3mounting holes are aligned.3 Drive Phillips pan screws in the 3threaded holes at the bottom of thestand until they are tight.To remove the stand from this unitUnscrew the Phillips pan screws indicated by above “➂”screw holes. After the screws are removed pull the stand up toward the rear of theunit. Be careful not to drop the stand when you remove it.AAAAAAAAA• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll freecustomer support line found on the cover of this manual.front sidefront sidefront side➀➁➀screw holes➂user manual(1EMN25079)quick start guide(1EMN25081)remote control(NF801UD)batteries(AAA x 2)registration card(1EMN24699)screw kit for attachingthe stand(1ESA20208)AC power cord(WAV0162LW001)
