25IntroductionENGLISHFRANÇAISDEUTSCHNEDERLANDSESPAÑOLITALIANOPORTUGUÊSSVENSKACONNECTING TO A TV DIRECTLYNOTE75-Ohm video and audio cables are supplied with the T585. SCART and S-Video cables can be purchased from your local NAD retailer.WARNINGDo not connect the Digital Audio Output of this DVD player to your receiver unless you are connecting the DIGITAL OUT jack of this DVD playerto an AV decoder that has the Dolby Digital or DTS decoding function. High volume sound may damage your hearing as well as the speakersf er(Refer to Initial Setup Settings, Audio).NOTES• Refer to the owner’s manual of your receiver as well.• Before you connect the T585 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet beforemaking any connections.• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.• The output sound of the T585 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, thespeakers may be damaged by a sudden high volume sound.• Turn off the receiver before you connect or disconnect the T585’s power cord. If you leave the receiver power on, the speakers may be damaged.S-VIDEO of the T585 to theS-Video of the TVComposite VIDEOOUT Jack of the T585to the compositevideo of the TVSCART/RGB OUT Jack of theT585 (EURO version) to the 21-pin SCART of the TVCOMPONENT VIDEOOUT Jacks of the T585to the component videoof the TVTV or monitor withaudio/video inputsT585 Safety.qxd 3/23/2006 4:12 PM Page 25