17CHAPTER 4N ETWORK A DMINISTRATIONP AGEU SING THE N ETWORKA DMINISTRATION P AGEEach SuperScript laser printer has a built-in web page thatallows you to perform network administration tasks.Accessing the Network Administration PageOnce you’ve assigned an IP address to your printer’s NICyou can use a web browser, such as Navigator or InternetExplorer, to access the Network Administration page.note: See Chapter 3 for instructions on assigning theprinter’s IP address. The printer’s IP address then appearson the Network Settings page under the TCP/IP NetworkInformation section, protocol address entry.To access the Network Administration page, open yourbrowser by double-clicking on its icon.1. Go to the URL Configuration Page, the URL ishttp:// address>/configure.html.2. Click on the Network Administration link. This displaysthe Network Administration page.You can access the following functions through the NetworkAdministration page:System FunctionsReset: Click here to reset the NIC and allow newsettings to take effect. The NIC’s connection with thenetwork is fully reinitialized, but its connection with theprinter controller is not. To reset the connection with theprinter controller, turn the printer off and on.Factory Defaults: Click here to restore factory defaultvalues on all NIC parameters. You should restore factorydefaults if you move the printer to a new network or ifthe NIC was set up improperly the first time. Rememberthat this option clears all settings you have defined forthe NIC. You must turn the printer off and on again forthe factory default settings to take effect.Unit Status: Click here to view the current state for eachprotocol and NIC port available on your NIC. For eachsupported protocol (Novell NetWare, TCP/IP, orAppleTalk), the top line displays the protocols supportedThe Network Administration Page