4872.10 Fault InformationFault Information is displayed by selecting “Fault Information” from the left side of the screen.Fault information of hardware unit is displayed in Fault Information.(1) If “Clear All” button is clicked, the following process runs.The following process runs in server web console. Restore the health status of this server to normal status Restore the failure status of all resources in this server to normal status If the resource is disabled with failure, change the resource’s enable/disable status toenable status. If the cores are deconfigued(At this time, the core information will not be displayed at“Core Status”), these cores will be configured to the system as enabled status. (Thisfunctionality is for Non- COPT (Capacity Optimization) Model only. )(2) Clicking “Enable/Disable” enables to move to Enable/Disable Component screen.(3) Display Fault sensor information.Name : Fault sensor status(1)(2)(3)IMPORTANT: If this server is powered on, this operation is not executable.Please make sure this server is powered off before run thisoperation. If “Clear All” button is clicked, “Faults cleared successfully.”will be displayed.
