552system1 targetThis target is regarding the system.system1/nic1 targetThis target is for the network settings of the system.Below is the property of the target.ipaddress :Set the network IP address for the system as staticIt is valid when committed=1 is set.subnetmask :Set the network subnet mask for the system as staticIt is valid when committed=1 is set.usedhcpSpecify whether if DHCP for the network IP address of the system is used or not.DHCP is enabled when usedhcp=1 and this setting is valid when committed=1 is set.defaultgatewayaddressSet the IP address for the default gateway.It is valid when committed=1 is set.committedValidate the property settings such as ipaddress, subnetmask,usedhcp anddefaultgatewayaddres when committed=1 is set.macaddressDisplay the mac address of the management board.IMPORTANT:• Don’t use set command which changes the MAC addressbecause it might cause malfunction of the management firmware.• It is not possible to set IP address, subnet mask, default gateway,DHCP at the same time. Set and commit(committed=1) each value one by one.• Set the address of IP Addr/IP Mask/Gateway Addr within thenetwork of the same segment.• Set an arbitrary unused address for Gateway Addr even ifGateway does not exist. It is not possible to disable the GatewayAddr.• When setting a network, conflict check of IP address is executedfor 10-20 seconds. During the check it is not possible to set theother network newly. Wait for a moment until the check is done.• While setting the network or operating the system, the conflictcheck of IP address is executed periodically. If any confliction isdetected, the IP address and its IP mask will be treated asinvalid,=0.0.0.0. After removing the factor of the confliction, setthe network again.
