Setup and Operation 2-45Use the following steps to copy or update configuration files.1. Select “Maintain System Configuration Diskette” from the Main Menu.2. Remove the ECU diskette from the diskette drive and replace it with the configu-ration diskette that came with the option board.3. Select “Copy/update CFG files” from the menu.4. Press Enter. A screen appears showing the availableconfiguration files available.5. Select the configuration file you need to copy. You can only copy one file at atime. Press Enter.You are prompted to remove the configuration diskette.6. Remove the diskette and replace it with the ECU diskette.After replacing the diskette, the CFG file is copied onto the ECU diskette.7. Repeat Steps 5 and 6 to copy all the configuration files you need onto the ECUdiskette.ExitSelect this option to exit the EISA Configuration Utility.If you are setting up the system for the first time and you have a SCSI device (such as aSCSI hard disk), see “SCSI Setup Utility” later in this section.PCI Devices and Plug and Play ISA BoardsWhenever you install a PCI device or Plug and Play ISA board in the system, run the ECUand select “Configure Computer or Peripheral Devices.”This configuration procedure automatically loads configuration information and adds thePCI device or Plug and Play board to the configuration. Select “Step 3: View or Edit De-tails” to check system parameters and “Step 4: Examine Required Switches” to print outsystem configuration information.Be sure to select Step 5 in the Configure Computer or Peripheral Devices menu and saveyour configuration.
