222. Projecting an Image (Basic Operation)❹ Selecting a SourceSelecting the computer or video sourceNOTE: Turn on the computer or video source equipment connected to the projector.Detecting the Signal AutomaticallyPress the SOURCE button once. The projector will search for the availableinput source and display it. The input source will change as follows:COMPUTER1 → COMPUTER2 → COMPUTER3 → HDMI → DisplayPort→ VIDEO → S-VIDEO → VIEWER → SLOT → COMPUTER1 → ...• With the SOURCE screen displayed, you can press the SOURCEbutton a few times to select the input source.TIP: If no input signal is present, the input will be skipped.Using the Remote ControlPress any one of the COMPUTER1, COMPUTER2, COMPUTER3, HDMI,DisplayPort, VIDEO, S-VIDEO, VIEWER, NETWORK, or SLOT buttons.Selecting Default SourceYou can set a source as the default source so that it will be displayedeach time the projector is turned on.1. Press the MENU button.The menu will be displayed.2. Press the ▶ button twice to select [SETUP] and press the ▼ but-ton or the ENTER button to select [BASIC].3. Press the ▶ button five times to select [OPTIONS(2)].4. Press the ▼ button five times to select [DEFAULT SOURCESELECT] and press the ENTER button.The [DEFAULT SOURCE SELECT] screen will be displayed.(→ page 136)5. Select a source as the default source, and press the ENTER but-ton.6. Press the EXIT button a few times to close the menu.
