Phone System ProgrammingFor the i-Series12 NVM-2e/i-Series Quick Setup Guide Chapter 3: Phone System ProgrammingPhon e System Progr am mingFor the i-SeriesVoice Mail Required Hardware and SoftwarePhone System Hardware and Software RequirementsHardwareEach analog Voice Mail port requires one analog port on the ASTU card. The NVM-2eintegrates with the 28i, 124i (as long as it is not fully expanded), 28i/124i commonized, andthe 124ie (as long as it is not fully expanded).SoftwareAnalog Voice Mail is supported in all i-Series software versions.Required Phone System Programming➻ 0004 - Automatic Extension Circuit Type(Use Phone Programming. Applies to 28i/124i commonized, 124ie)Make sure that you have already connected the NVM-2e to the phone system before you usethis program.Run program 0004 to automatically set up extension circuit types.Note: Running 0004 after the system is set up may require that you re-program certaindevices (such as DSS Consoles and DCI’s).➻ 0005 - Extension Circuit Type (Whenever possible, use 0004)(Use Phone Programming. Applies to 28i/124i commonized, 124ie)Assign circuit type 3 to analog Voice Mail ports.Assign circuit 9, order 2 to digital Voice Mail ports. (Remember to program both the odd-numbered port and the next consecutive even port reserved by the system.)Note: Entering circuit type using 0005 may require a manual entry in 1001. [In 1001 - BasicExtension Port Setup (Part A), Item 1: Telephone Signaling Type, enter 1 for DTMF.]Availability: All versions of the NVM-2e integrate with the i-Series.IMPORTANTBefore you program the phone system, make sure that you have performed all steps inChapter 2: Installing the Voice Mail (beginning on page 5 ). This simplifies program-ming the phone system. Specifically, make sure that you have connected the NVM-2eto the phone system.