3-50 Configuring the System10. Move the J5G1 jumper back to pins 1 and 2 so the system can restartin normal operation mode.11. Replace the system unit cover (see “System Unit Cover”). Connectsystem power cables and external options.12. Power on the system and launch the BIOS Setup utility before POSTand recustomize your BIOS settings.Clearing a PasswordIf you forget your password, use the following procedure to clear yourcurrent password and to set a new one. NECC recommends using needle-nose pliers to move a jumper.Jumpers are set correctly at the factory for yourconfiguration. Only change (or check) the appropriate jumper setting if youforgot your password. Otherwise, keep the jumpers at their factorysettings.Access the BIOS Setup utility and record your customized settings. See“The BIOS Setup Utility.”Starting the system in Configure mode resetsBIOS settings to their factory defaults.Before jumpering the system for Configure mode, write down anycustomized BIOS settings. When the system is started in Normal mode,press F2 to bring up the BIOS Setup utility. Recustomize your BIOSsettings.1. Power off the system and monitor and unplug any peripherals.The system power must be off before removingthe cover and changing a jumper setting.2. Remove the system unit cover (see “System Unit Cover”).
