Configuring the System 3-513. Locate the J5G1 jumper block on the system board (see “SystemBoard Jumper Settings”). Move the jumper to pins 2 and 3. Thisjumper setting brings the system up in Configure mode when it isrebooted.4. Replace the system unit cover (see “System Unit Cover”). Connectsystem power cables and external options.5. Power on the system. The BIOS Setup utility launches immediatelyafter POST, and no password is required. The Maintenance menu isactive.6. Select the Clear All Passwords field. Press Enter.7. A Setup Confirmation window appears with the prompt, “Clear AllPasswords Now?” The default is Yes. Press the left or right arrowkey to toggle between Yes and No. Select Yes and press Enter toactivate the choice.8. Select the Exit menu with the left or right arrow key. Press Enter toexit saving changes. Press Enter again to confirm that you wish toexit the BIOS Setup utility.9. Power off and unplug the system and any external options. Removethe system unit cover (see “System Unit Cover”).10. Move the J5G1 jumper back to pins 1 and 2 so the system can restartin normal operation mode.11. Replace the system unit cover (see “System Unit Cover”). Connectsystem power cables and external options.12. Power on the system and launch the BIOS Setup utility before POSTto set a new password (see “Setting a Password”) and recustomizeyour BIOS settings.Minitower Riser Board Jumper SettingsThe minitower riser board has two jumper blocks that let you configurethe system as follows:! enable or disable LAN on the riser board! configure the system for either a 2- or a 3-wire fan.The following figure shows jumper locations on the riser board.
