1015. Using On-Screen MenuRESETReset the adjustment value that has been selected in [GEOMETRIC CORRECTION] (return to the initial value). Itbecomes ineffective when [OFF] is selected for [MODE].• The adjusted value can be reset also by pressing the 3D REFORM button for two seconds or longer on the remotecontrol.[EDGE BLENDING]This adjusts the edges (boundaries) of the projection screen when projecting high resolution videos using a combina-tion of several projectors in the up, down, left and right positions.MODEThis enables or disables the EDGE BLENDING function.When [MODE] is set to [ON], the [MARKER], [TOP], [BOTTOM], [LEFT], [RIGHT], [BLACK LEVEL] and [BLENDCURVE] settings can be adjusted.MARKERSet whether to display marker or not when adjusting the range and display position. When turned on, a magentamarker for adjusting the range adjustment and a green marker for adjusting the display position will be displayed.TOP/BOTTOM/LEFT/RIGHTThis selects the EDGE BLENDING locations on the left, right, top and bottom on the screen.The following settings can be adjusted when an item is selected. (→ page 64)CONTROL �������������� Enable TOP, BOTTOM, LEFT and RIGHT functions�RANGE ������������������� Adjust the range (width) of the edge blending�POSITION �������������� Adjust the display position of the edge blending�BLEND CURVESet brightness for the [EDGE BLENDING] sections. (→ page 68)BLACK LEVELAdjust the black level of the [EDGE BLENDING] section. (→ page 69)
