1105. Using On-Screen MenuUsing the Reference Lens Memory Function [REF. LENS MEMORY]This function serves to store the adjusted values common to all input sources when using the LENS SHIFT, ZOOMand FOCUS buttons of the projector or the remote control. The adjusted values stored in memory can be used as areference to the current.PROFILE ���������������� Select a stored [PROFILE] number�STORE ������������������� Stores the current adjusted values in memory as a reference�MOVE �������������������� Applies the adjusted reference values stored in [STORE] to the current signal�RESET�������������������� Reset selected [PROFILE] number [REF� LENS MEMORY] to the factory default settings�LOAD BY SIGNAL �� When you switch signals the lens will shift to the lens shift, zoom, and focus values for the selected [PRO-FILE] number�If no adjusted values have been saved to [LENS MEMORY], the lens will apply [REF� LENS MEMORY]adjusted values� Alternatively, if no adjusted values have been saved to [REF� LENS MEMORY], the unit willreturn to factory default settings�FORCED MUTE ������ To turn off the image during lens shift, select [ON]�NOTE:• Adjusted values in [REF.LENS MEMORY] will not be returned to default when performing [CURRENT SIGNAL] or [ALL DATA] for[RESET] from the menu.• To store adjusted values for each input source, use the Lens Memory function. (→ page 93)[LENS POSITION]Move the lens position.HOME �������������������� Set back the lens to the home position�TYPE ���������������������� Select this for using the lens unit NP39ML-4K� The lens position will be adjusted to the appropriate position�[LENS CALIBRATION]The adjustment range of the zoom, focus, and shift of the [LENS MEMORY] is calibrated.Be sure to carry out [LENS CALIBRATION] after replacing the lens.Applicable lens unit: NP16FL-4K/NP17ZL-4K/NP18ZL-4K/NP19ZL-4K/NP20ZL-4K/NP21ZL-4K/NP31ZL-4K
