513. Convenient Features⓫ Storing Changes for Lens Shift, Zoom, and Focus [LENSMEMORY]The adjusted values can be stored in projector memory when using the LENS SHIFT, ZOOM and FOCUS buttonsof the projector. Adjusted values can be applied to the signal you selected. This will eliminate the need to adjust lensshift, focus, and zoom at the time of source selection. There are two ways to save adjusted values for lens shift,zoom, and focus.Function name Description pageREF. LENS MEMORY Adjusted values common to all input signals. At the time of installation,two kinds of adjusted values can be stored.If no adjusted values are stored in [LENS MEMORY], adjusted valuesfrom the selected profile ([REF. LENS MEMORY]) will be applied forlens adjustment.→ page 110LENS MEMORY Adjusted values for each input signal.Use the adjusted values for the signal with a different aspect ratio orresolution. The adjusted values can be applied at the time of sourceselection.→ page 93NOTE:• For using the lens unit NP16FL-4K, NP17ZL-4K, NP18ZL-4K, NP19ZL-4K, NP20ZL-4K, NP21ZL-4K, and NP31ZL-4K, be sure tocarry out [LENS CALIBRATION] after replacing the lens unit. (→ page 17, 110)• For the lens unit, NP16FL-4K, the storable value as [LENS MEMORY] feature is for [FOCUS] only.• The [LENS MEMORY] feature is not available for the lens unit, NP39ML-4K.
